mode=3 (broadcast)īroadcast policy: transmits everything on all slave interfaces. ![]() This mode provides load balancing and fault tolerance. This selects the same slave for each destination MAC address. The bond’s MAC address is externally visible on only one port (network adapter) to avoid confusing the switch. The other one will become active, only when the active slave fails. mode=1 (active-backup)Īctive-backup policy: In this mode, only one slave in the bond is active. It transmits packets in sequential order from the first available slave through the last. Types of Network BondingĪccording the to the official documentation, here is the types of network bonding modes. Additionally, link integrity monitoring, may be performed. The behaviour of the bonded interfaces depends upon the mode generally speaking, modes provide either hot standby or load balancing services. The Linux bonding driver provides a method for combining multiple network interfaces into a single logical “bonded” interface. Linux allows us to bond multiple network interfaces into single interface using a special kernel module named bonding. Network bonding can be used in situations wherever you need redundancy, fault tolerance or load balancing networks. ![]() If one interface is down or unplugged, the other one will keep the network traffic up and alive. It will increase the network throughput, bandwidth and will give redundancy. ![]() Network bonding is a method of combining (joining) two or more network interfaces together into a single interface.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |